Repair Work

Note: This first post appears to all happen in one day, but in fact, took place over a week and a half. Future postings will be more current.

Most recently. I have been commissioned to work on a “problem” dulcimer. The “fingerboard” on top of the oak fretboard was actually a dark stain.

Repair1

The main problem, however, was a 6 1/2 fret that was added after the fact. The crown of the fret appeared to be too high. It was ground quite flat, but still caused a great deal of string buzz.

Repair3

I removed the frets,

Repair4

and the clunky string guide,

Repair5

and began the process of sanding and flattening the oak fretboard.

Repair6

The fretboard is sanded flat and level.

Repair 10

Nice and smooth…

Repair 7

This is the new fingerboard before preparation.

Repair 8

The prepared fingerboard awaits new frets.

Repair 9

The frets are placed based on the scale length.

Repair10

The frets are cut to length and pressed into the fingerboard.

Repair11

The frets are trimmed and the fingerboard is glued onto the fretboard.

Repair12

One of several coats of polyurethane is applied.

Repair13

 

Leave a Reply

Your email address will not be published.